How to define a slot in footprint

website dimension a slot Under the Annotate Tab, pick Centerline Bisector Pick both nodes at the quadrants of the slot as shown below This will create a center line dimension a slot In this article, we will review the basics of slot dimensioning, recommendations from ASME , and slot callouts for CAD software

dimension a slot However if the slot is horizontal or vertical use the TechDraw_Dimension_Horizontal_Extent or vertical equivalent If the slot is angled then,  Apart from creating vertical or horizontal slots, one can create an angled slot by using angle dimension Also there can be different ways to  Where I work it is standard procedure to dimension slots from end to end, so QA can easily caliper the parts to check

Share

Share

Link

Turn off sharing Copy link

See all details